![]() ![]() ![]() ! appropriate wiring BY A QUALIFIED ELECTRICIAN-FAILURE TO DO SO COULD CAUSE SERIOUS INJURY The power cord must be wired into the swimming pool timer box or pump junction box with Should the unit come wired for 110V, it will haveĪ 3 prong plug fastened to the terminated end of the power cable for use with a controller. The power cord comes prewired, with a 6 foot cord, designed to go directly to the power source. Please note that the cell cap is installed at the factory directly on the cell cord. The cell cord comes pre-wired with a plug, which will fit directly to the plug located at the bottom left side of the power Line up keyholes over screw heads and rest controlīox on the screws, pulling down until securely seated.Ĥ. Line and fasten screws leaving the heads about 1/8” from wall. Drill holes in mounting surface in a level Keyholes in the back of the control boxĪre 16 inches apart, center-to-center, and approximately ¼ inch in diameter. Control box must be mounted with the appropriate wall anchors for your wall. Never mount the control box above combustibleģ. The controls, but not so high as to cause tension on the cell wire. Height above the ground should be enough to comfortably read Control box must be mounted on a vertical surface. Doing so will damage the cell and void your warranty.Ģ. Wire from the cell cannot be lengthened or Control box must be mounted within 3½ feet of POOL THING cell. COMMERCIAL POOL OPERATORS MUST COMPLY WITH ALL STATE AND LOCAL REGULATIONS.ġ.POOL THING must be wired in accordance with A BONDING CONDUCTOR not smaller than No.8 AWG (8.4mm ) must be connected from the grounding lug found beneath the controlīox to a similar lug on the pump motor, which must be connected to all metal parts.UNIT MUST NEVER BE MOUNTED INLINE WITH DRINKING WATER SUPPLIES.Any modifications could be hazardous and will void the warranty. For continued protection against fire, only replace with a slow-blow fuse of the same type and rating.Do not dismantle the electrodes, detach them from the end-cap or cut the electrode wire.To reduce risk of injury, do not permit children to use this device.USE EXTREME CAUTION WHEN OPENING CONTROL BOX.ONLY A QUALIFIED TECHNICIAN SHOULD INSTALL AND SERVICE POOL THING.Precautions should always be followed, including the following: When installing and using this electrical equipment, basic safety It is a violation of Federal Law to use this product in a manner inconsistent with its labeling. POOL THING® LISTING DATA FOR COMMERCIAL UNITS. POOL THING® INSTALLATION LAYOUT SCHEMATIC DRAWING. POOL THING® LOW MAINTENANCE SYSTEM NOTES FOR RS MODELS. PART NUMBERS & DESCRIPTIONS.11ĬONTACTING THE POOL THING® HELP LINE. POOL THING® CONTROL UNIT DIAGRAM (C260, C390 & C520). METER NEEDLE STUCK IN EXTREME LEFT (CENTER FOR RS MODELS) POSITION, LIGHT IS ON. METER NEEDLE STUCK IN EXTREME RIGHT POSITION. POOL THING® CONTROL UNIT LAYOUT & OPERATION. For Installation Instructions, See Pages 2 – 4 ![]()
0 Comments
Leave a Reply. |